Home > Discussion Groups > Braille Scale

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=47210&messageid=1113823253
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

Advertisement
 Return to Index  

Dragon + Voyager StuG IIIG

June 8 2012 at 10:06 AM		   (Login FlyingHaggis)
Missing-Lynx members
Hi chaps

I've just posted this but it didn't appear so apologies if you've just seen it.

This is the Dragon StuG IIIG with the Voyager update set, some of the PE was so small it hurt! The postman has just arrived with the Shurzen so I ought to pop off to the cave for some soldering.

I'll be doing this model for Scale Modelling Now, Geoff Coughlin's internet based magazine so look out for the article soon. http://www.scalemodellingnow.com/

[linked image]

[linked image]

 
 Respond to this message   
Responses

  1. Clean PE work, MG shield - RobertKru on Jun 8, 5:17 PM
    1. Re: Clean PE work, MG shield - Jamie Haggo on Jun 8, 5:28 PM
      1. stored in Stug n/t - RobertKru on Jun 9, 5:16 AM
      2. Re: Clean PE work, MG shield - Rob on Jun 14, 5:15 AM
     


Terms and Conditions of Use Report abuse