Home > Discussion Groups > Braille Scale

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=47210&messageid=1113823253
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

Advertisement
 Return to Index  

Works a treat....

July 29 2012 at 2:58 PM
  (Login Spacewolfdad)
MODERATORS ONLY - Braille


Response to Wonderful idea...

Hi Mutsuhito,

I have just tried this method out and after a few tries I was producing rivets quite easily. I just did four 0.5mm holes in a square for now and will try some different sizes over the next few days. This is going to make life so much easier, thank you very much for this wonderful tip.

All the best,

Paul

 
 Respond to this message   


Terms and Conditions of Use
Report abuse