Home > Discussion Groups > General

Message posting guidelines:

  • Full real names must be used at all times.

  • A valid e-mail address must be provided. (This is not optional)

  • Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.

  • Registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=47207&messageid=1113822984

Please read our Community guidelines before posting.

By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.

Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.


 Return to Index  

Sulphur free

July 16 2012 at 12:11 PM
Jon Greenwood  (Login JonGreenwood)
Missing-Lynx members
from IP address

Response to Platinum/Addition Cure Slicone

I am going to do a small test of the clay/plasticine I have, it's by Newplast and apparently is sulphur free..apparently they use this stuff to make Wallace and Gromit, so I'd rather use this stuff then anything else happy.gif
The other alternatives are quite expensive, Chavant and I have found Kleen Klay that's a bit cheaper.If this stuff I have dont work, I'll get some of the Kleen Klay.I think, as I ain't doing a 2 part mold so dont need anything to elaborate, I'll just use a dam/box outta the clay.It should be easy enough for a simple block mold.

All this hassle to get some decent boots for figures....why can't someone just produce a set of 1/35th scale boots?, for various nations/periods...grrrrrrr.

But thanks a lot for the advice/info guys, put my mind at ease and set me on the right track.


 Respond to this message   

Terms and Conditions of Use
Report abuse