Home > Discussion Groups > General

Message posting guidelines:

  • Full real names must be used at all times.

  • A valid e-mail address must be provided. (This is not optional)

  • Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.

  • Registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=47207&messageid=1113822984

Please read our Community guidelines before posting.

By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.

Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.


 Return to Index  

Tamiya printed zimmerit...

July 26 2012 at 6:11 AM
Marcus Nicholls  (Login niklz1138)
Missing-Lynx members
from IP address

Response to As for Zimm...

Hi Ray,
I just finished Tamiya's Elefant and I tried the zimmerit sheet. Whilst it's a nice idea, the detail is a little shallow and it also needs trimming out from the backing sheet. I have included a couple of shots of my Elefant with home-applied putty zimm plus a shot showing the printed zimm under a thin layer of XF57 Buff paint. Even if you're really accurate with the modelling knife (as you can see, I wasn't!), you'll still need to apply a little filler where the sheet surrounds the bolt heads etc..

I hope you don't mind me partially hijacking your thread to show these pics!

[IMG][linked image][/IMG]

[IMG][linked image][/IMG]

[IMG][linked image][/IMG]

This review model will appear in TMMI 203, September 2012

 Respond to this message   

  1. That would be right .. - Ray Blythe. on Jul 26, 2012, 6:27 AM

Terms and Conditions of Use
Report abuse