Home > Discussion Groups > General

Message posting guidelines:

  • Full real names must be used at all times.

  • A valid e-mail address must be provided. (This is not optional)

  • Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.

  • Registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=47207&messageid=1113822984

Please read our Community guidelines before posting.

By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.

Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.


 Return to Index  

You would use it to make welds the same way...

July 27 2012 at 9:39 AM
Mike Roof  (Login MikeRoof)
Missing-Lynx members
from IP address

Response to and...

That you would use thinned Squadron Green Stuff (or other polyester putty) to make weld beads.

What I do is lay down two parellel narrow strips of tape, use the brush to put a line of thinned putty between them, texture the putty (I use a chisle-shaped toothpick), then remove the tape.

This product appears like it would work more or less the same way. The potential application seemed immediately obvious when I read the description.

Most of these welds were made using this technique with thinned Squadron Green Stuff:

[IMG][linked image][/IMG]

[IMG][linked image][/IMG]

[IMG][linked image][/IMG]

The very small or short welds, for example around the tool clamps and brackets, were made with two-part epoxy putty (here Miliput gray), but all of the the longer green welds are Green Stuff putty.


This message has been edited by MikeRoof from IP address on Jul 27, 2012 9:43 AM

 Respond to this message   

  1. Thanks Mike for your help! - Kevin Krueger on Jul 27, 2012, 12:08 PM
    1. thxs - Andrew Deeley on Jul 28, 2012, 2:53 AM

Terms and Conditions of Use
Report abuse