Home > Discussion Groups > General

Message posting guidelines:

  • Full real names must be used at all times.

  • A valid e-mail address must be provided. (This is not optional)

  • Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.

  • Registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=47207&messageid=1113822984

Please read our Community guidelines before posting.

By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.

Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.


  << Previous Topic | Next Topic >>Return to Index  

LF Square/Rectangular Headlight

September 25 2011 at 11:05 AM
Ian Barraclough  (Login barra733)
Missing-Lynx members
from IP address

Does any manufacturer out there make generic square or rectangular clear headlights (similar to the Elf round ones)suitable for use in 1/35 scale. I'm modifying a truck and would like to swap the round lights for rectangular ones.

 Respond to this message   
roy chow
(Login roy_chow)
Missing-Lynx members

You'd think

September 25 2011, 11:22 AM 

someone who models cars and trucks may good info on this. I don't know the Missing-Lynx equivalent for car builders however.

Roy Chow
AMPS 1st Vice President

 Respond to this message   
John Tapsell
(Login John_Tapsell)
Missing-Lynx members

Little Cars

September 25 2011, 11:42 AM 


Try looking at the Little Cars website - they do a whole series of 'Little Lenses', including a few rectangular ones. They may be a bit small for what you're after but I use the round ones regularly and like them.



 Respond to this message   
Rob Skipper
(Login RobertSkipper)
Missing-Lynx members

This Thread...

September 25 2011, 11:56 AM 

 Respond to this message   
Ian Barraclough
(Login barra733)
Missing-Lynx members

Thanks All...

September 26 2011, 6:22 AM 

... I'm going to have a go at making my own part from an old clear plastic sprue.

 Respond to this message   
Christopher Mrosko
(Login panzermrosko)
Missing-Lynx members

Other options as well!

September 26 2011, 9:30 AM 

Other options as well! you can simply re-cut one of the large MV lenses to correct shape or use foil/silver Mylar and shape it to correct shape then place a drop of 5 minute epoxy onto the backing!

 Respond to this message   
Jim Carswell
(Login leopardC2)
Missing-Lynx members

SKP Models

September 27 2011, 3:00 PM 

They have a new Merkava 4 set out with rectangular headlights:http://www.skpmodel.eu/index2.php?sekce=en_doplnky&id=136
Might be close?


 Respond to this message   
  << Previous Topic | Next Topic >>Return to Index  

Terms and Conditions of Use
Report abuse