Home > Discussion Groups > Figures

Message posting guidelines:

Full real names must be used at all times.

A valid e-mail address must be provided. (This is not optional)
Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=47212&messageid=1113823220
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Working scale.....

October 18 2010 at 7:39 AM
clive harman  (Login blackbartmodels)
Missing-Lynx members
from IP address

Response to Scale for cans

Hi Miran,

I'll send you an email off forum - tonight.

I tend to work in half scale & scale the end product as needed - so anything smaller than half scale is OK- however, experience has taught me that below 1/20th you loose a lot of the finer detail.


 Respond to this message   

  1. Re: Working scale..... - miran Flores on Oct 18, 2010, 2:55 PM

Terms and Conditions of Use
Report abuse