I just purchased new ribbon cables and installed one in my PS2. When it turns on, the little balls that usually fly around the screen fly into just one ball that stays there. The wave sounds still occur but the screen freezes. I can move throughout the setup screens, but when I got to browser, it reads : Reading disc... for about 2 secs then stops and all it reads is the memory cards.

Odd.. Try cleaning the laser with a q-tip.. I'll ask the other techs if they have seen this before.

I'm not sure that the disc is even spinning at all.

Normally if the balls don't move it means you have to reset the clock.

I set the clock and the balls are now moving. I still can't get it to read the disc though. The same thing still happens when I go to browser.

how do you reset the clock?

through the configuration settings.

Again I ask, what do I do to fix my problem?