Hi to all my Hyperscale friends,
here is a very small but important update : after a long struggle Iwas able to get a satuisfactory finish on the upper rear fuselage area where the reinforcing strips posed a big problem .!!!
To get this result I reinforced the back of a wet&dry paper with Scotch tape and cut small stripes of paper about 0.5 mm. narrower than the interspace width of the reinforcing strips on fuselage and used such small strips to sand the interstrips spaces . (hope this could help you David) .
Actual problem I'm dealing with is the rescribing of the auxiliary air intakes on engine cowlings .
That's all for today