take a wire 16ga or 14ga and strip about 3/8" insulation off. Take the bare end and twist it around so it looks like one of those kids wind spinners on a stick. Kinda make it flat as you can and only about 1/4 in around. Get some solder flux and dip this end in it and heat it up with your iron and dab solder on it but don't get carried away just enough to cover the copper but not make a glob on it. Get some sandpaper and sand it flat and smooth and round the edges so no wires stick out and it fits into the little insulater deal. I've done dozens of these and it works..
********
riding and wrenching on Milwaukee vibrators since 1971
Posted on Jul 5, 2009, 10:32 PM from IP address 69.149.224.130
®