Just thought I would throw this out there. I bought one of those aluminum CV carb flanges for my shovelhead off of ebay. I was told that it could be pressed on but two different shops said the tolerance was too close so instead I put the flange in the oven at 500 degrees for a hour, and the carb in the freezer for the same amount of time. With a some careful alignment and hammering, the CV is now feeding my bike. I hope this saves someone a bit of time and frustration.
Buy the ticket-take the ride!
Posted on Jun 13, 2012, 7:05 AM from IP address 220.127.116.11