i'm installing a new belt drive set up..,and when i re-installed the bearing support palte...,it is binding the trans mainshaft...,not too tight...,but enough so that i cannot turn the shaft by hand...,is this normal..,or is my support plate warped???
The shaft turns nice a free without the bearing support plate..,as i snug it up...,the shaft gets harder to turn.
Thanks ahead of time guys...,i'll just be sitting here......,waiting.......,still here....,ANYONE GOT AN ANSWER???
"The sum total of excellence is good sense and method. When these have passed into the instinctive readiness of habit, when the wheel revolves so rapidly that we cannot see it revolve at all, then we call the combination genius."
-Samuel Taylor Coleridge (1772-1834)
Posted on Aug 4, 2012, 11:02 AM from IP address 98.181.23.110
