you just need the correct inner spacer. I probably have a couple of the bearings at the shop,I will check. You will need to remove the old outer races from the hub.If you have a welder just lay a 3'8" bead along the middle of the old race, let it cool and it will fall out. Or drive them out.Indi-shops should have special bearing removal tools, that lock in the races and are then tapped out. Your self, use a large flat screwdriver,and a hammer, and alternating side to side, do not bugger the hub.
Posted on Aug 4, 2012, 8:33 PM from IP address 24.116.28.247
