Return to Index  

The accu shot mount

May 25 2007 at 4:26 PM

Matt in the Bayou  (Login nutriahunter)
YFOT


Response to 220 scope mounting

I have is a LOT harder metal than the Factory one piece I had (the mount as well as the allen screws) Might try a piece of tire patch (for air tubes) cut it out to go under the stop pin the crank it on down, might help from slipping as well as not scratching the blueing. Gorilla glue is at any hardware shop, pretty pricey and make sure you don't lose the cap! It'll turn into a bag of cement left out in the rain(remember this stuff expands alot so a lil goes a ways) Good luck to ya.

Matt

 
 Respond to this message   
Responses


Click The Banner To Visit sites.

D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present.