Thanks for all the info guys, now I need to dig in and learn a few things...I found various plans for a compressor, doesn't look too challenging, I received a reply on the parts I need....what I could use now is some instruction (pictorial?) on pulling this thing down. I pulled the action out of the stock and noticed that there is a plastic end cap / hood like piece attached at the back of the receiver tube, nothing obvious about how it removes.....drive pins back there too, retaining the end cap for the spring? Sorry to sound so noobish, I've worked on many powder burners, several CO2 guns, and about any thing else you can think of, just not springers and don't want to make this beeeech worse......
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present.
