Return to Index  

Is your go-to guy

September 16 2011 at 8:07 AM
  (Login VAFarmer)
YC


Response to Who repairs/services GAMO's?

Rich?

If not look up RichinMich. He did Gamo's for years, don't know what his status is here with the Yellow, but google him.

If he is going out of business, I can tell you how I do it......

I have a big stationary vise ready and locked down.
Take a propane torch and heat the thread side of the pivot screw, be careful, heat slowly so you dont mess up the finish. Action needs to be out of the gun for this, BTW. Also take the breech seal out, might melt it.
Once heated to where it feels very warm to the touch, almost hot.
Insert whole action into vise, barrel up. Make sure that outside dia. of lockdown screw is just above top of jaws. Cinch the vise down and get it tight, be careful here and go slow, too much, you will bend the ears. Too loose, and you wont get any pressure relief.

Take a screwdriver of the exact size, and insert into the flat screw, and push with all your weight on it, while turning the handle counterclockwise with a set of channel locks.

Once the screw is out, you will need to drive out the screw sleeve, and then your detent should pop right out. I just grab the spring and strech it a little, polish the ends then lube it up.
You can replace it, though.

Hope this helps,


God bless,

Farmer

 
 Respond to this message   
Responses


Click The Banner To Visit sites.

D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present.