Rich. from Mich.
(Login peterdragin)
YF | barrel | November 12 2006, 8:29 PM |
Well it's not to hard but what holds the barrel from unscrewing is the barrel pivot bolt bushing.
The only other problem is when you machine a new barrel for it you have to figure out how to make the bushing line up since the bore it goes in is machined AFTER the barrel in installed into the pivot block.
And the barrel is also lock tite on it also.
You do have a lathe that machines Metric threads don't you,bcause it's an odd ball thread at M14 X 1.0. I priced a threading die for that thread and it has to be made up special and the quote was $75.00 and would take 3 to 4 weeks to get.
This message has been edited by peterdragin on Nov 12, 2006 8:33 PM
|
|
|
