Since I installed the overtravel mod I became curious about the overall length of trigger travel so I did some measuring. I measured from the back of the GTX blade about halfway up. Here is what I found. Overall trigger travel from rest to stop screw is just under 11/32". That breaks down like this: Length of 1st stage - 1/4". Length of 2nd stage - just under 3/32". Somewhere in that 3/32" is where the sear trips and the rest is what is left of the overtravel. I didn't think to measure before the mod and I really like my adjustments and don't want to risk losing them to measure without the mod. How does this compare to a GTX without the overtravel mod? I realize there will be variations because of adjustments, but just an average.
"You've come far, pilgrim."------"Feels like far."
"Were it worth the trouble?"----"Ah, what trouble?"
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present.
