The (new) Crosman Forum, your first and last stop for all things Crosman
 Return to Index  

You could...

March 18 2012 at 7:48 PM
No score for this post
Pumpmeister  (Login Pumpmeister)
Crosman Forum Member
from IP address

Response to Won't happen.

Turn Barrel to .429!

I assume you're referring to a 9MM/.357 Barrel from Numrich's ,which is .440 O.D.?

You could Make a shroud with .750tube which has a .625 I.D. Make a spacer with a 7/6" hole thru
areas & just turn Liner to .435 & put in set screw 8-32 X.3125!Just make tubing 2-3" longer*
than barrel than make a brake w/ 3/8" hole at Muzzle(drilling through a Piece of T6 .750 Rod
3" long). drill through Pependicular(Across) 3 - 1/8" holes) for vents) then go in with a 7/16"
dril only to about 2.75" Measure length of barrel protruding from breech,then add 3" to that*

T6 Alum. Rod should be turned to fit I'D' of tube and made long enough that part supports at least 5/8" inch of barrel(muzzle end) I am in Process of making this for a 1325 Project of mine

You can Omit the center spacer and drill 2 1/8" holes at downward angle on either side of
the air to prevent condensationon barrel hth


P.S. any questions email me @ above address

Lock - N - Load!

Scoring disabled. You must be logged in to score posts.Respond to this message   

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member