Home > Discussion Groups > 1/48 Scale

Message posting guidelines:

Full real names must be used at all times.

A valid e-mail address must be provided. (This is not optional)
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=47210&messageid=1113823253
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.


 Return to Index  

Hi Andrew - I should have mentioned what I plan to do....

November 19 2016 at 9:01 AM
Bruce Culver  (Login baker24)
Missing-Lynx members

Response to thanks

The inboard ends of the Tiger II ausf B engine deck PE grills have a couple of projecting points at the corners. I'll cut those down to make those ends as rectangular as I can. Not perfect, but it is highly unlikely that Hauler or anyone else will produce a set of PE screens for a limited aftermarket conversion set for the Panther ausf A or D.

 Respond to this message   

  1. A BIG thanks to you all - Tony Ormandy on Nov 19, 2016, 2:37 PM
    1. Mesh covers for Panther A - A Partial Solution - Paul McMahon on Nov 22, 2016, 7:16 AM
      1. Good spot - Andrew Deeley on Nov 22, 2016, 3:27 PM
      2. Bigger Thanks - Tony Ormandy on Nov 23, 2016, 5:14 AM
        1. Your most welcome - Paul McMahon on Nov 23, 2016, 6:20 AM
          1. Even better - Andrew Deeley on Nov 23, 2016, 9:25 AM
            1. Regrettably, the MR early Jagdpanther rear deck has a problem..... - Bruce Culver on Nov 23, 2016, 2:45 PM
              1. Good spot - Andrew Deeley on Nov 24, 2016, 12:21 PM
                1. Andrew, if you have a Panther A/D conversion from TWS, - Bruce Culver on Nov 24, 2016, 9:44 PM
                  1. Re: Andrew, if you have a Panther A/D conversion from TWS, - Andrew Deeley on Nov 25, 2016, 3:37 AM
                    1. Andrew, the front intake grill is the same size as the Tamiya G2.... - Bruce Culver on Nov 25, 2016, 10:46 AM
                      1. Re grills. - Andrew Deley on Nov 25, 2016, 2:27 PM

Terms and Conditions of Use
Report abuse