Guys,
Here is a little seating tool I chewed out today after I got some of the PileDrivers in and had a look see at them. I have read the trouble some have had with these shifting POI from not getting them seated good and square. I have not shot any of the pellets yet, so I am not sure how the seating tool will work. Will be shooting these in the morning and have a look see...
I did stick on the PD's in the chamber of my Condor and once the tool is rested against the barrel I gave the tool a spin and it did put the pellet in the center of the bore from what it looked to me... I will see if I can post the art on this...
http://im1.shutterfly.com/procserv/47b6cc32b3127cce8fe9bc2714ae00000016108BcNXLVo3aq
http://im1.shutterfly.com/procserv/47b6cc32b3127cce8fe9bc5b14d200000016108BcNXLVo3aq
http://im1.shutterfly.com/procserv/47b6cc32b3127cce8fe9bc28959100000016108BcNXLVo3aq
Just keep in mind here guys I just chewed this out and was fast and nasty about it, for a look see. If it works like I think it should I will have to make a little better looking one and maybe do a little polishing on it before I flame color the 400 series stainless steel I made this from... So looking as close as I tried to make the PIC's here, you will see its been chewed on LOL... I did try to knurl it a little by hand on my anvil, but it was going to take more time than I wanted to spend just yet, so I stopped that for now as well. Will do a better job of the knurling if the seating tool works out ok...