Anyone willing to take on a small (?) project?

I've looked high and low for an adapter for a Talon/Condor that will (safely!) allow for a pressure gauge and a QF adapter. I've seen some that folks have made, but have been unable to get my hands on one.

Had one fellow several months back agree to make one, but he never followed through.

Here is what I'm after...


One end goes into the bottle, the valve on the other end. Adds a couple inches to the LOP. Seems as though it should be simple enough, but I am obviously not a machinist.

I'd like to say that others might be interested... as I've had some folks on the Talon forum say they'd be interested in one, but I cannot say just how serious they are.

If any of you gents might want to take on this project, please email me.