Re-acquiring a thread ?March 27 2012 at 8:07 PM
|Rock Keiser (Login Harleyrider05)|
What is the best way to reacquire a thread after you remove a piece from your lathe & find out you need to make a few more cuts ? Not sure how to get threading dial back in syinc.
- I have always had to start bt aligning the part to the tool.... - John Lucas on Mar 27, 2012, 9:25 PM
- When Cutting threads on the lathe, you always make the male half - james perotti on Mar 28, 2012, 7:17 AM
- How about this video showing how? - Ed Canoles on Mar 28, 2012, 9:17 AM
- If the work piece permits - Cal on Mar 29, 2012, 12:21 PM
- Got it !!! Thanks to all - Rock Keiser on Mar 30, 2012, 12:44 AM