Return to Index  

Weld buildup, turning, 4 jaw centering, steady restin' a 2.5" diameter 14'........

May 6 2012 at 8:35 PM

Ed Canoles  (Login nced1)

marine shaft and babbit bearing repair using lathe, milling & boring machines, etc.
How about THIS "garage" workshop??

I'm just imagining a lathe with a spindle bore that will accommodate a 2 1/2" shaft! As a "seat of the pants" chip/scrap maker I was a bit awed by all the processes this guy mastered doing the repair and perhaps others here will appreciate the vids and PERHAPS even apply some of the techniques to theit airgun metal work.

This message has been edited by nced1 on May 6, 2012 8:39 PM

 Respond to this message