Return to Index

can anyone post a vid on how to do vtaper with basic lathe..im new sorry..nt

June 16 2012 at 8:26 PM

(Login robnewyork)
YF

I know a bunch of the basics..just wondering how the stepup is done on ldcs?

[linked image]

"i never was much for book learnin"

This message has been edited by robnewyork on Jun 16, 2012 8:43 PM
This message has been edited by robnewyork on Jun 16, 2012 8:30 PM
This message has been edited by robnewyork on Jun 16, 2012 8:27 PM

Respond to this message

Responses

vtaper? - Scott Hull on Jun 16, 2012, 10:08 PM

like an ldc step up..from lets say 3/8th to 7/16th? - robny on Jun 16, 2012, 10:26 PM

I think I know what you're talking about - Scott Hull on Jun 16, 2012, 10:50 PM

that sounds about right man. - robny on Jun 17, 2012, 9:23 PM

Not a video, but here's a compound crosslide on a benchtop lathe - Derrick on Jun 17, 2012, 10:06 AM

thanks ..makes sense - robny on Jun 17, 2012, 9:26 PM

You can use the compound feed, set at the angle you want, but - james perotti on Jun 17, 2012, 11:48 AM

nope..just short one.if you have seen - robny on Jun 17, 2012, 9:29 PM

Not video, but a pic... - Dave Dunn on Jun 17, 2012, 4:14 PM

makes perfect sense.. - robny on Jun 17, 2012, 9:32 PM

Be aware that your tool edge.............................. - Dave on Jun 17, 2012, 10:02 PM

that clarifies questions i havent even asked yet.. - robny on Jun 17, 2012, 10:32 PM

Rob, here is a good video... - Lon on Jun 20, 2012, 2:04 PM

thanks man..that guy - robny on Jun 21, 2012, 4:01 PM