Hi Grant!! Don't let a few p$%# ants ruin the picnic I for one would still like to have you make some trays, I have three marauders,Two in .22 and a .177 the bolt for which mic's 4.51mm. I really don't care if crosman makes them or not I would prefer your's. If they were going to offer them, Should have had them available at release time as it is they will most likely be like the current clip situation, Never in stock and a long wait to get. Where as your offerings can be counted on. Regards,

Greg

You are Right. They are not Worth Arguing with, but I just cant Resist Sticking it up them when they open their Poisonous Mouths, Lol. It always results in Me making Myself Unpopular in the Process. I will have a Think about things, but I wont be going near any more Custom Talk on the Yellow because the Membership is much more Varied than on the Green with a smaller Interest in the Subject. All I can recommend is that Custom Parts Chat about My Stuff will be here on this Forum Only from NOW on.

Regards Grant

After a few Hours Peace, Ive spent a bit of Time this Afternoon on a few in 22 cal and I will do an equal amount in 177 cal. Hopefully 36 will keep a few People happy for a wee while, Lol.

[IMG][/IMG]

Grant.

Grant  I think the single shot is a great option when bench shooting. You know, take a shot or two of one pellet Have a sip. Hmm lets try this odd pellet. Have a sip. Can't Wait!

Brian.

measurements taken from my 177 bolt, Probe Dia.2.06mm for a length of 6.7mm, taper is 45 degrees, length of taper 1.5mm, To a Dia. of 4.51, For a length of 19mm, Again flairing up to 11.10..... I posted a reply to your inquiry on the yellow, But figured you would get it sooner here on the blue. Regards,

Greg