Clips arrived today, I don't feel bad about taking one apart for dissection now, Grant need any measurements?Machinist drawings,Drop a note. Regards,

Greg

I will have to take one of mine apart when they arrive, but I would like a Sneek look inside one of dem dar Mags of Yours, if you could take a picture or two please?

Thanks Grant.

PS. Check out the Classifieds. .

Grant,I'm e-mailing pics of the clip innerds, If you look at the back of your clip you can see the spring's timing port directly above the loading window. The clip's ability to load and cycle is controlled by tension on the center screw and engaging the spring's unpinned end in the slot at the back of the pellet indexing wheel.If you look closely at the loading port, One half of the pellet acts as a stop in it's recessed port on the housing. The pics aren't that clear, But from my viewing it I see the possibility of converting to .25 cal on the horizon. Regards,

Greg