Guys, just traded for a Prod, pumped it to 2800 psi several different times, and everything was fine until this morning. Went to shoot it and it had lost all of its charge. When I tried re-pumping, I heard air hissing from around the gauge, and when I lightly pressed on the face of the gauge, the sound increased. Released all remaining air, then went to remove the gauge and it 'wobbled' back and forth when putting a wrench on it and still threaded in place. I tried putting new teflon tape on the threads, but that didn't solve the problem. Question is, should the gauge wobble back and forth when it's installed? I'm thinking not, which would simply mean that I need to replace the gauge. Anyone experienced a similar problem? Thanks in advance - Ted
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums from people under 18 years old, only with legal guardian(s) present.