I have my PCP charger attached to the dive tank which has a hose with a 1/8" BSP fitting. My Air Arms S400 fill probe just screws into the end of hose where there is a female attachment.

Will a Marauder probe fit (i.e. remove my AA probe and just screw in the Marauder probe) or does it use a different system?

Thanks,

Daniel
Way down in New Zealand

just has a screw-off cap on the muzzle end of the gun that reveals a standard quick-connect male fitting (sometimes also called a Foster fitting, I believe). I have had all my airguns changed to that system, so no more adapters with worn-out O-rings for me--ever! Go to the PyramydAir site, look up the Marauder and take a look at page 3 of the manual for a pic of the filling setup.

Thanks - see on p3 of the manual there's no probe, but that female adaptor is attached to the hose.
Is it attached via a 1/8" BSP screw in connection like probes for Air Arms / FX / HW / BSA rifles?

Daniel
Way down in New Zealand

Link is below. This the female part that attaches to the male part on the Marauder.

http://www.pyramydair.com/s/a/Female_quick_disconnect_adapter_with_male_thread/832