<< Previous Topic | Next Topic >>Return to Index  

My hammer spring setting on the Marauder is walking

September 25 2010 at 11:25 AM
Weldman  (Login Weldmannnn)

as I shoot it. Where is that set screw again I think I read about here?
I can't find the post now that I need it.

Thanks!

 
 Respond to this message   
AuthorReply


(Login SirTonySteel)
YFOT

Previous posts say

September 25 2010, 4:11 PM 

Set the adjustments where you wnat them and take it down an lock tight 'em. All will be well.

 
 Respond to this message   
Weldman
(Login Weldmannnn)

How do you get the hammer-adjustment screw OUT

September 25 2010, 4:17 PM 

then? Mine backs out to a fixed point and stops. How does one get it out to put some lock tite or such on the threads?

Thanks much.

 
 Respond to this message   

Jeff P
(Login pad617)
YFOT

This should help...

September 25 2010, 6:41 PM 

http://www.network54.com/Forum/79537/message/1284620522/Help+with+Marauder+Stroke+Adjustment+Changing-

Pretty much have to take off the barrel and breech as one unit then the hammer can be accessed enough through a slot in the tube to tighten doen the stroke adjustment set screw.

Jeff P

 
 Respond to this message   
Weldman
(Login Weldmannnn)

Yessir that's the thread I was looking for. Thanks!

September 25 2010, 6:58 PM 

-Weldman

 
 Respond to this message   
Current Topic - My hammer spring setting on the Marauder is walking
  << Previous Topic | Next Topic >>Return to Index  

D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums from people under 18 years old, only with legal guardian(s) present.