Disco Trigger AdjustmentApril 22 2013 at 6:57 PM
|Larry (Login IceManLarry)|
I have a Disco with a 3 screw trigger mod that I purchased from a
forum member. Can someone tell me how to adjust the screws to lighten
the trigger pull. Right now the trigger pulls a little heavy for me, and
it has a lot of front to rear play. I see 2 screws on the back of the trigger
housing and 1 in front of the trigger guard. I could just start turning screws,
but I would rather know what each screw does and where to start adjusting to
avoid messing things up.
|This message has been edited by IceManLarry on Apr 22, 2013 11:16 PM|
Pretty good description here.
|April 23 2013, 12:59 AM |
|April 23 2013, 8:12 AM |
Thanks for the info.
All is perfectly clear now!
Will work with the trigger
what I did...
|April 23 2013, 4:30 PM |
Make sure the gun is not loaded. Degass the gun. Take the stock off and the half of the trigger housing. Then you can pull the trigger and see what the screws are doing. You can even cock the gun and pull the trigger to get the break jhst where you want it. Like I said, no gas and no pellet you can test to your hearts content.
|May 3 2013, 11:36 AM |
Thanks for the info. It worked well!
glad I was able to help!
|May 3 2013, 2:09 PM |
Usually I'm more of a leach on these forums leaning the ins and outs of the guns. Happy I could contribute back!