I have pretty much all the bits to build a TS250 Supa Five engine (or even an ETZ251 if you want) scattered all over in my lockup. Anything you'd need like new gaskets and shit are now easily had from some mail order place that Stefan knows bout.
What I don't have is a piston that matches a barrel but pistons are cheap enough and somebody could build a good crank out of the bits of old ones I have lying around if I had access to somebody's crank press.
Important Disclaimer Advice given in this forum may or may not be accurate, safe or wise. Always use common sense and when in
doubt assume that any advice given is incorrect and liable to end in terminal engine or part failure, personal
injury or death. www.ratbike.org and its contributors can accept no responsibility for anything, anywhere, at any time, regardless of cause.
Important Disclaimer
