Return to Index  

and a little more

August 21 2011 at 10:52 AM

Sam Dwyer  (Login samd)
Owner
from IP address 120.147.108.15


Response to X7 - s.Jp.Abt 512

 

There are some areas that need attention in regards to welds on this model, particularly around the hull front and rear armour. I used Tamiya epoxy putty 'quick type' to replicate the welds missing.

After mixing the 2 parts together, i rolled a very fine snake of putty and applied it to the areas needing welds.. I then textured it with the back end of a #75 drill bit, put backwards in a pin vice. A fresh #11 blade was used the trim the edges. This technique was first shown in an early issue of AFV Modeller, and is dead easy, and effective.

I've still got some tidying up of these welds to do:

[linked image]

[linked image]

[linked image]

Sam

www.schwerpunkt.com.au

 
 Respond to this message   
Find more forums on Network54Create your own forum at Network54
 Copyright © 1999-2017 Network54. All rights reserved.   Terms of Use   Privacy Statement