Return to Index  

Bottom Wing Fix on the Vac

September 27 2011 at 7:36 AM
Dan Smith  (no login)
from IP address 65.102.179.249

All,

I think I fixed the undersurface problem on the single sided vac mold on my recon aircraft. It's just skinned with some thin plastic that was feathered (sanded) at the edges and glued in place after a little embossing with a pen and ruler. The fixed one is primed in grey below.

[linked image]

On to the top wings!

Cheers.

 
 Respond to this message   
Responses


HyperScale's Group Build Guidelines

The objective of this Group Build is to encourage as many modellers as possible to build their kits and share their progress via words and photos on this Forum.

You are welcome to post general construction tips or relevant reference information and photos to this Forum too.

This Group Build will feature WWI Aircraft Kits.

  1. This Group Build will run until 31 December, 2011.

  2. Build as many kits as you like.

  3. Conversions, aftermarket and scratchbuilding are all permitted.

  4. Any markings are acceptable.

  5. Document your progress and do a write-up on your build - where did you have trouble, what improvements did you make, what markings did you choose and why? It would be GREAT if everyone would do a writeup and submit it to HyperScale as a Feature Article.
     

Posting or replying to messages on The Group Build Forum requires visitors to register. If you have not already registered on one of HyperScale's other Forums, you will need to:

  1. First register with Network 54, the Forum provider.Click here to register with Network 54.

  2. Then, you can sign up for HyperScale's forums. Click here to sign up for HyperScale's forums.

Your user name and password will give you full posting privileges to all of HyperScale Forums.

 

free counters