Respond to this messageReturn to Index
Original Message
  • Uh huh, learnt that the hard way turning nylon pieces...

    • Posted Jun 12, 2007 9:55 AM

      I thought that you needed "sharp" and speed didn't make as much difference, and it really didn't until the piece got pretty little and I tried cutting at oring groove....But while it was larger, nylon was great to cut, even at pretty high speed. (My bit was razor sharp tho)

      Catchya on the Flip Side.....

      Emerald Wolf -- really needs to get a small lathe one of these days....
    Your Name
    Your Email
    (Optional)
    Message Title
    Message Text
    Options Enable formatted text (Huh?)
    Also send responses to my email address
     
    Notice: This is a moderated forum. Your post will not show up until a moderator approves the message. If you regularly have full posting privileges, you may have to login first.