Login  /  Register  
  Home  -  Forum  -  Classifieds  -  Photos  -  Links     

 Return to Index  

Ross & Werbyford

June 17 2017 at 12:58 PM
ArnieO  (Login ArnieO)

Response to Compression ratio question

Thanks , I should have included the cam . It's from Oregon a562/566 lift with230/236 duration , I also have the old reliable street master intake and found the article on here on porting them . It's a 3 pedal car I plan to run a regular off the shelf head gasket set not a thin set . Like I said it's not a pure 1/4 mile car just a fun driver for weekends and take to the strip once in a while . I guess if I do end up with a small ping I could back the timing down then kick it up at the strip with some good gas. I just didn't want to over kill on the compression and have it rattle -n- knock , but still want to get all I can out of it (trying to walk that thin line) Thanks again ArnieO

This message has been edited by ArnieO on Jun 17, 2017 1:02 PM

 Respond to this message