Login  /  Register  
  Home  -  Forum  -  Classifieds  -  Photos  -  Links     

 Return to Index  

Trying to pin a drive train vibration - Bad Yoke??

October 8 2017 at 10:06 AM
Bob S.  (Login convertable)
Members

Cobra kit car, very short driveshaft. Had some vibration and noise. U joints seem fine,so while I was under I did the 180 with the shaft at the pinion. Took the car to the HWY and much worse. A week later I have the shaft balance checked, close but they did make a change. Now the vibration is the same either way I mount it. It's a cast yoke, and I'm guessing I need to replace it. (can this be checked in any way?) What would be the truest running yoke for pinion (9-inch)??

 
 Respond to this message   
Responses