Login  /  Register  
  Home  -  Forum  -  Classifieds  -  Photos  -  Links     

  << Previous Topic | Next Topic >>Return to Index  

482 side oiler oil pressure

April 20 2017 at 6:36 PM
Robby  (Login Forddude)
Members

Ok guys I got it back together and pumped the oil pressure up. I used a 500 rpm 3/8 drill and got 72 lbs oil pressure with 10-30 oil. Will this suffice? Thanks....

 
 Respond to this message   
AuthorReply
Leland
(Login lhstanford)
Members

I'm sure you know that's no indication of PSI while running

April 20 2017, 7:05 PM 

I got 60 PSI while priming the system on my 406 with one of POPS blueprinted HV pumps using a 3/8 drill, but after installation I now get 80+ PSI on cold start, around 55 PSI after warm up. So, yes the 72 PSI is plenty.

 
 Respond to this message   
jgkurz
(Login jgkurz)
Members

Seems OK

April 20 2017, 7:20 PM 

I put a Melling HV pump in my recent build and got about 85psi with my drill and 10w30 breakin oil. While running and hot it had 98psi @ 6000rpm. When the oil was just warm it would go over 100psi. WAY TOO MUCH. 72psi with the drill seems OK to me.


    
This message has been edited by jgkurz on Apr 20, 2017 7:26 PM


 
 Respond to this message   

Barry_R
(Login Barry_R)
Members

Agreed - - Sounds normal n/m

April 21 2017, 1:45 AM 

Barry Rabotnick
Survivalmotorsports.com

 
 Respond to this message   
Robby
(Login Forddude)
Members

Ok good deal

April 21 2017, 7:39 AM 

I think the drill I have is a little weak so it will probably be a touch higher when running. It had wayyyyyy to much pressure before. It was 140 cold above 2000. So should be good now. Thanks all!

 
 Respond to this message   
 
  << Previous Topic | Next Topic >>Return to Index