Login  /  Register  
  Home  -  Forum  -  Classifieds  -  Photos  -  Links     

 Return to Index  

FS: Northern Cal: Parts to Swap an FE into a 1967/1968 Mustang, 1965 F100 Door Hinges

May 3 2012 at 2:57 PM

TorinoBP88  (Login TorinoBP88)
Members

Engine mounts, block plates and frame plates, clutch pedal, z-bar and almost all MSC small clutch linkage pieces to put a FE into a 1967 or 68 mustang. Ill even through in a shroud. Pick up or you pay shipping. $600

Door hinges from a 1965 F-100 two sets, left and right. $40 plush shipping.

Moroso deep sump pan WITH matching pick up. Has rivet holes in side of pan from a pan dip stick. $120 + ship.

C5 4v intake and C6AE-R heads, $200 for the set plus about a million dollars for shipping, that stock intake is a 75 pounder! happy.gif

Rear Mustang sway bar. Bolts to axel. end links to frame missing. $45 + shipping.

Three Speed toploader, 67 fairlane/mustang. New bearings, $150, ill give you a bell for $10 if you get the trans.

Used 1968 Mustang power steering box (not actually power box, but came from a power steering car so it should be the faster ratio. speed up the steering on a manual steering car. $75.


I will consider selling my built and running GT 416 FE, and 1964 fairlane side emblems, F100 emblem, mustang side mirrors, ITM 4 speed body, other msc stuff...


Ohh, i have an ORIGINAL 1968 Mustang spare wheel/tire, great for shows! and jack and jack wrench = $250


********************************************
1964 Galaxie 4Dr Sedan, 289, 3spd (re-installing OD soon), a Texas Sargent's Personal Car
1967 416 GT engine, BIBO Wide R TL
1968 428 'C', '69 SCJ heads, Gal Wide R TL

Oh and a Bicycle daily driver.


    
This message has been edited by TorinoBP88 on May 8, 2012 10:19 PM
This message has been edited by TorinoBP88 on May 3, 2012 3:12 PM
This message has been edited by TorinoBP88 on May 3, 2012 3:10 PM
This message has been edited by TorinoBP88 on May 3, 2012 3:09 PM


 
 Respond to this message   
Responses