Home > Discussion Groups > New Products

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=78968&messageid=1113823358
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Re: Can you digi scan say a figure or headset in 35th and reduce to 48th

September 5 2006 at 8:58 AM
  (Login www_printapart_com)
Missing-Lynx members
from IP address 66.0.187.154


Response to Can you digi scan say a figure or headset in 35th and reduce to 48th

I am sorry to say that I can't help you out in that department. We do not offer any type of design work or 3D Scanning. You would have to produce the data in the scale that you would like it to be in and we would print the part for you. If you have any other questions, please let me know.

 
 Respond to this message   


Terms and Conditions of Use
Report abuse