Home > Discussion Groups > Dioramas

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=78970&messageid=1113823195
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

I make my own...

December 26 2001 at 9:02 AM
  (no login)
from IP address 208.208.7.27


Response to Dio name

Justin,

Another approach is to make your own. I use K&S Brass lengths, usually 1/2 wide. Shine it up with some fine steel wool, apply dry-transfer lettering, cut to length then seal with Futura Floor Wax. Important to keep your finger prints off of the brass until you seal it.

You can see my results at:
http://www.mortarsinminiature.com

HTH
Thanks,
Kevin Keefe

 
 Respond to this message   


Terms and Conditions of Use
Report abuse