Home > Discussion Groups > Dioramas

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=78970&messageid=1113823195
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

3D printed Dio

May 26 2017 at 12:11 PM
Jeremy Connaughton  (Login Jeremy-Connaughton)
Missing-Lynx members
from IP address 82.36.153.74

Hi Folks
a fully 3D printed diorama, (apart from the paint and foliage happy.gif)
[img][linked image][/img]
[img][linked image][/img]
[img][linked image][/img]
[img][linked image][/img]
[img][linked image][/img]
[img][linked image][/img]
[img][linked image][/img]
[img][linked image][/img]
was trying out how small I could go
comments welcome
thanks for looking
Jeremy

 
 Respond to this message   


Terms and Conditions of Use
Report abuse