Home > Discussion Groups > Dioramas

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=78970&messageid=1113823195
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

  << Previous Topic | Next Topic >>Return to Index  

2x4's in 1/35

May 14 2002 at 7:43 PM
  (no login)
from IP address 24.247.180.239

Hi, i was wondering what the dimensions of a 2x4 wooden board would be in 1/35 scale, and also what would be a good material to use to make one?

 
 Respond to this message   
AuthorReply

(no login)
205.188.200.57

close enough

May 15 2002, 7:46 AM 

Lumber is not cut to true dimension, but 2x4 inches would be 1.45 by 2.9mm. An eight foot length would be 69.66mm.

 
 Respond to this message   

(no login)
154.5.231.189

Model railroading shops carry precut HO scale lumber

May 28 2002, 1:51 PM 

2"x4"x8' would be 1.45 x 2.90 x 66.67mm

Modern day 2x4s are actually 1.5"x3.5" = 1.09 x 2.54 x 66.67mm

Ken

 
 Respond to this message   
Current Topic - 2x4's in 1/35
  << Previous Topic | Next Topic >>Return to Index  


Terms and Conditions of Use
Report abuse