Return to Index

yes for RX and HW conversions

June 23 2009 at 9:04 AM

Arnold Smith (Login chardosmith)
YC

I have been inside my R1 with gas ram, a RX and a RX2 all of which had a conventional looking piston with a seal that would all interchange - RX and R1 use the SAME seal. Depending on how you lube the outside of the piston, the piston seal and the inside of the receiver, there will be varying amounts of lube to burn.

My R1 conversion was wearing on the top of the rear piston skirt to the receiver tube. a few Old School Buttons from JM made it much nicer.

Arnold
"Betcha Can't Have Just One"

This message has been edited by chardosmith on Jun 23, 2009 9:05 AM

Respond to this message

BAR/PSI Conversions FPE by Airhog number of fills by Airhog

Click On Banner

D I S C L A I M E R JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present.