Removing the "regulation"....

April 18 2017 at 7:30 PM
Robert  (Login BigTinBoat)
YF12


Response to I think you nailed it...

I take those 850psi regulators and bump them up to about 2800. Not too hard to do with a stack of belleville washers. Just takes some trial and error till you get the stack right. You can also "override" the regulator completely by making a solid spacer to replace the washer/spring stack.
I've never done this as those ASA on/off valve seem a bit hard to control. Did not want 4500 psi in my guns.

 
 Respond to this message   
Responses


Airgun Calculators    Num of fills calc    Capacity Calc

******** Kalibrgun High quality, superb Accuracy, outstanding Value. ********





D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present.