looks like

April 18 2017 at 8:50 PM

robny  (Login robnewyork)
YF


Response to Mrod CP-1M, problem chambering pellets

u need to pull the barrel off and chamfer the rear of it.. A slight taper with a dremel tool like you were doing a crown , then reinstall and test again.. repeat till u get the desired result.. the lowest angle possible is ideal, 60 degrees or below and shallow


    
This message has been edited by robnewyork on Apr 18, 2017 8:52 PM


 
 Respond to this message   
Responses


Airgun Calculators    Num of fills calc    Capacity Calc

******** Kalibrgun High quality, superb Accuracy, outstanding Value. ********





D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present.