The rivet holes in the HW95 barrel pivot block are a slip fit to the rivet......

May 16 2017 at 6:58 PM

nced  (Login SpringerEd)
YF12


Response to question-----both Diana and Daisy use pins in there pistols

and the hole in the latch rod is a bit larger so it's "free moving" on the rivet. Actually, the HW method of flaring the rivet ends is a simple and secure way of retaining them so I really don't want to mess with what works well. Since a couple ball bearings stuck on the rivet ends with grease and then squished in the vice is a simple way to
expand the ends I like this procedure. LOL....if you but the factory HW95 rivets the ball bearings don't even mess up the bluing!


    
This message has been edited by SpringerEd on May 16, 2017 6:59 PM


 
 Respond to this message   

Airgun Calculators    Num of fills calc    Capacity Calc

******** Kalibrgun High quality, superb Accuracy, outstanding Value. ********





D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present.