Yes the small pellets wont go far and wears out fast, It just got the job done,

May 26 2017 at 8:28 PM

Mike Ellingsworth  (Login 4888blues)
YF12


Response to I think you'll be happier with a cast in bore lead lap.The better fit and much greater

Later I'll go back and get the bore lapping tool made up with a full size lap, pretty sure that wiping lead was not the ticket over regular lead. I did heat the bore before I poured the lead other wise it could flash, also heated the ladle before melting the lead into it.

rotating handle looks great I'll look into that.

Thanks Scot.

Mike E.


    
This message has been edited by 4888blues on May 26, 2017 8:41 PM


 
 Respond to this message   

Airgun Calculators    Num of fills calc    Capacity Calc

******** Kalibrgun High quality, superb Accuracy, outstanding Value. ********





D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present.