Common standard sizes

June 16 2017 at 12:12 PM

C. Jones  (Login limbshaker)
YF12


Response to 2.9 X 1.78 90 duro o-ring is what I need

FX tends to use a lot of common SAE "standard" size orings.

2.9X1.78mm crosses over to a 006 size oring. If you go asking for a metric size you will hit a lot of dead ends...

A hose shop or any oring place should have an 006 on the shelf. Probably not in 90 duro, but that may not be critical. If so, ask for it in Viton. Viton is a little higher duro usually as standard. So is urethane.


Or just order 100 from McMaster Carr for a few bucks.


    
This message has been edited by limbshaker on Jun 16, 2017 12:33 PM


 
 Respond to this message   
Responses


Airgun Calculators    Num of fills calc    Capacity Calc

******** Kalibrgun High quality, superb Accuracy, outstanding Value. ********





D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present.