Return to Index  

If I had to do it over again I would.....

June 18 2017 at 5:40 PM
Ronald  (Login GunNut10)
YF12


Response to Re: I made it from a piece of band steel......

probably use aluminum or brass. The steel was a real PIA to bend. I used a vise and bent it around some metal pipe. Heating it with a propane torch makes it bend easier. Used files and a belt sander for the taper. Truck bed paint finished it off.

Ronald


    
This message has been edited by GunNut10 on Jun 18, 2017 7:05 PM


 
 Respond to this message   
Responses


Airgun Calculators    Num of fills calc    Capacity Calc

******** Kalibrgun High quality, superb Accuracy, outstanding Value. ********





D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present.